Skip to content
ALL POSTS

Cleaning a lift: what your cleaners can do, what to leave, and why it matters

Elevator Repair Specialists
Neglected lift pit filled with debris and old cabling before clearing

Cleaning a lift sounds like a matter of appearances, but dirt in the wrong place can stop one altogether. Doors are the most common fault on any lift, and a door that cannot close properly because of grit is a lift that will not move.

The difficulty is that a lift has two kinds of space. One is for your cleaners. The other is for trained engineers only, and it is important that everybody in the building knows the difference.

What your cleaners can safely do

  • Vacuum the door sills on every clean. The doors run in these tracks. Grit, gravel and small bits of rubbish collect there, especially at the ground floor. A vacuum is the best tool for the job, used from the landing or from inside the car, never reaching into the gap.
  • Clean the car floor. Use a barely damp mop, and do not let water run towards the doors or the gap at the sill.
  • Wipe the walls, mirrors and handrails. Use a cleaner suited to the finish, and on brushed stainless steel, wipe along the grain.
  • Clean the buttons and panels properly. Spray the cloth and not the panel. Liquid sprayed straight on can get behind the buttons and into the electronics.
  • Keep the landings clean. Dirt on the landing ends up in the sills. A good mat at the main entrance helps a lot.

Choose a time when the lift is quiet, and prop nothing open while you clean. If the doors need holding, ask whether the lift has an independent service button, and how it should be used.

What they must leave alone

Cleaners, and any other building staff, should not:

  • Go into the pit, even for rubbish that has fallen in.
  • Go on top of the car, or into the shaft.
  • Clean inside the machine room, apart from anything your lift company has agreed.
  • Open the controller, or any panel that needs a key or a tool.
  • Oil, grease or spray anything. Household products on door tracks attract dirt and can make things worse.
  • Force the doors, or try to clean them while they are held open by hand.

If something has fallen down the gap, such as keys or a phone, leave it there and call your lift company. The car, and the risk of a fall, make this a job only for somebody trained.

What the engineer cleans

Some of the most important cleaning is done as part of your service visits, with the lift safely isolated:

  • The pit, which can collect rubbish, dust and water.
  • The car top, the door gear and the door tracks from inside the shaft.
  • The machine room and the equipment in it.

The photo at the top of this post shows a pit we were called to before it was cleared. A pit should never look like that. Debris can hide leaks and damage, get in the way of the engineer, and make the work less safe. If nobody has mentioned the state of yours in a while, ask on the next visit. A good lift company will be happy to show you.

Water is the one to watch

A wet floor at the entrance is more than a slip risk. Water that runs over the sill can end up in the pit, and water and lift equipment do not mix. Report it straight away if you see water in the pit, or leaks anywhere near the shaft or the machine room. If water is getting into the lift, take it out of service if you can safely do so, and call.

Does cleaning help with LOLER?

Not directly. The thorough examination under the Lifting Operations and Lifting Equipment Regulations (LOLER) is about finding defects that are, or could become, dangerous. A clean car will not change that result. A clean pit and machine room do make it easier for the examiner to see what they need to see, and our post on the difference between maintenance and LOLER explains how they fit together.

A simple routine

  • Every clean: sills vacuumed, car floor and buttons done, and anything unusual reported.
  • Weekly: walls, mirrors and handrails done properly, depending on how busy the lift is.
  • Every service visit: ask if the pit, the car top and the machine room are clean, and whether anything needs attention.

Busy buildings, entrances at street level and lifts used for deliveries or building work will all need more. A care home or a hospitality building may have its own hygiene routine, and the same rules apply: cloth not spray, and keep water away from the sills.

Give your cleaners a clear instruction to report what they notice. They use the lift more closely than almost anybody. If they spot a new noise, a door that hesitates or a step at the floor, it can be fixed before it turns into a breakdown. Our post on looking after your lift between services has more on what to look out for.

Need a hand?

If grit and door faults keep coming back, see lift repairs or talk to us about lift servicing and maintenance. We look after every make across Worcestershire, Gloucestershire, Herefordshire, Shropshire and the West Midlands.

Call 0800 999 1042 or ask for a call back.

Got a question about your lift?

Name, number and what you want to know. An engineer will ring you back.

Or call 0800 999 1042

Lift out of action? Ring us.

We answer our own phone. Every make, 24/7 call outs, and engineers working out from just north of Worcester, across the Midlands, London and the South.

Call 0800 999 1042 Request a call back